Document to be attached to the technical file for machinery to fulfil the requirements of Annex “VII” concerning essential health and safety relating to the design and construction of machinery according to the Machinery Directive 2006/42/EC
ISO 13849-1 Risk Assessment
ADVR technicians support machine manufacturers in drawing up risk analyses following the requirements of the Machinery Directive 2006/42/EC and harmonised standards. Risk assessment consists of a technical analysis of the hazards present in the machine to take the necessary protective measures to eliminate, reduce or mitigate the risk. Risk assessment according to ISO 12100:2010
Technical File
Compilation and formation of the technical file for machinery to fulfil the requirements of Annex “VII” concerning essential health and safety relating to the design and construction of machinery according to the Machinery Directive 2006/42/EC.
The technical file comprises the following:
- a construction file including:
- a general description of the machinery,
- the overall drawing of the machinery and drawings of the control circuits, as well as the pertinent descriptions and explanations necessary for understanding the operation of the machinery,
- full detailed drawings, accompanied by any calculation notes, test results, certificates, etc., required to check the conformity of the machinery with the essential health and safety requirements,
- the documentation on risk assessment demonstrating the procedure followed, including:
- a list of the essential health and safety requirements which apply to the machinery,
- the description of the protective measures implemented to eliminate identified hazards or to reduce risks and, when appropriate, the indication of the residual risks associated with the machinery,
- the standards and other technical specifications used, indicating the essential health and safety requirements covered by these standards,
- any technical report giving the results of the tests carried out either by the manufacturer or by a body chosen by the manufacturer or his authorised representative,
- a copy of the instructions for the machinery,
- where appropriate, the declaration of incorporation for included partly completed machinery and the relevant assembly instructions for such machinery,
- where appropriate, copies of the EC declaration of conformity of machinery or other products incorporated into the machinery,
- a copy of the EC declaration of conformity;
- for series manufacture, the internal measures that will be implemented to ensure that the machinery remains in conformity with the provisions of this Directive.
The manufacturer must carry out necessary research and tests on components, fittings or the completed machinery to determine whether by its design or construction, it is capable of being assembled and put into service safely. The relevant reports and results shall be included in the technical file.
- The technical file referred to in point 1 must be made available to the competent authorities of the Member States for at least 10 years following the date of manufacture of the machinery or, in the case of series manufacture, of the last unit produced.
- The technical file does not have to be located in the territory of the Community, nor does it have to be permanently available in material form. However, it must be capable of being assembled and made available within a period of time commensurate with its complexity by the person designated in the EC declaration of conformity.
- The technical file does not have to include detailed plans or any other specific information as regards the sub-assemblies used for the manufacture of the machinery unless knowledge of them is essential for verification of conformity with the essential health and safety requirements.
- Failure to present the technical file in response to a duly reasoned request by the competent national authorities may constitute sufficient grounds for doubting the conformity of the machinery in question with the essential health and safety requirements.